Who can say in detail under the axle, burning tile, cylinder, cylinder, storm what meaning.
The burning tile is mainly due to lack of lubrication or clearance between shaft and bearing caused by too small. The burning tile, the shaft neck surface will appear serious scratches, oxidation and burning blue. The sliding bearing work, there is a layer of thin film lubrication between bearing and shaft. If the lubrication bad, there is a direct friction between bearing and shaft friction will produce high temperature, while the bearing is due to the special high temperature resistant alloy material, but high temperature direct friction on the device still burned. Bush also may be due to excessive load, high temperature, lubricating oil impurities or abnormal viscosity caused by factors such as burning tile. Motorcycles also frequently burning oil, high temperature, blue smoke, noise, weak, unable to start serious engine scrapFailure: due to the high temperature, the piston expansion card in the cylinder, causing serious engine scrap. Due to excessive pressure piston and can not play, will spray thick flame.
The main solution is: to regularly check the oil and a high degree of quality, the replacement of oil, oil filter and air filter regularly. In the vehicle at the beginning (especially in winter) do not rapidly increase the engine speed, should keep the engine running idle for a few minutes, the engine at full lubrication started again.
Cylinder engine cylinder wall refers to the upper and lower direction to catch traces, serious will make the cylinder wall off a large area, causing damage to the cylinder and piston.Axle refers to the engine crankshaft and the crankshaft bearing adhesion, cause the lock can not rotate.The cylinder and the axle are related to engine lubrication, if the lack of engine oil, engine oil viscosity too long enough, oil duct blockage, impurities in the oil too much, all these will cause the cylinder or axle. In addition, the crankshaft and the crankshaft bearing clearance is too high will cause the axle.
Failure phenomenon is the cooling and lubrication system, and metal material thermal expansion and contraction and turn the use of one problem, of course, there may be several factors at the same time all together, to know the Formula One racing a ten cylinder engine working at the same time, will happen or shrink failure the phenomenon may be just a cylinder cylinder, mainly because of the piston ring and cylinder wall cylinder piston on the severe wear or fracture caused by the original, close the cylinder because after the engine room at the bottom of the lubricating oil into the cylinder combustion chamber, not completely out of the burning exhaust gas through the exhaust system is discharged out of the car. We saw a traffic jam behind the smoke a lot of white smoke in television, and in accordance with the size of the smoke can roughly determine the severity of failure, if this phenomenon is more serious. It is likely to cause oil to spill onto the runway, which will directly result in the high risk of other racing cars
