Who knows the power order of the six wire stepper motor?
Alternating between 1 and 2 phases alternately. Because the resolution is improved and the operation is smooth, each excitation signal can go 9 degrees, so it is also widely adopted. If the 1 phase excitation method is used to control the stepper motor, the excitation sequence is shown in the figure above. If the excitation signal is transmitted backward, the step motor is turned back.
At each instant there will be two coils at the same time. Because of its large torque and small vibration, it is the most exciting mode at present. Each excitation signal can go 18 degrees. If the 2 phase excitation method is used to control the stepper motor, the excitation sequence is shown in the figure above. If the excitation signal is transmitted backward, the step motor is turned back.
At each instant there is only one coil conducting. The utility model has the advantages of small power consumption, good accuracy, but small torque and large vibration, and each excitation signal can be driven 18 degrees. In the 1 phase excitation method to control the stepper motor is transferred, the excitation sequence as shown above. If the excitation signal is transmitted backward, the step motor is turned back.
The excitation mode of stepping motor can be divided into full excitation and half step excitation, in which the whole step excitation has 1 phase excitation and 2 phase excitation, while the half step excitation is called 1-2 phase excitation. As follows:
