Why does an ice maker have a light without ice making?
This or that problem will appear in the process of ice making machine, Shanghai will now have extension of common problems and solutions of ice machine are summarized as follows:Symptom: ice maker doesn't work.Reason: the most common is the power supply is not energized.Solution: select the correct power source.
Symptom: the machine enters the ice removal program (the pump stops working, the compressor stops cooling), but the ice does not fall off. ????????Reason: two way solenoid valve is damaged. ????????Solution: replace solenoid valve or outside loop.
3. symptoms: compressor has been able to work, refrigeration, water pump has been working, pumping, ice continues to thicken, but always can not automatically enter the ice removal program, ice fall. ??: water temperature measuring probe fault, the intelligent control system can not effectively perceived temperature work, misjudgment of program error, or controller failure. ?????Solution: the multimeter is used to measure the temperature of the resistance probe (the water temperature in the water tank near 0 degrees C, remove the control box of the three core lines, two lines on both sides of the resistance test), such as resistance in more than 27K, it was judged as controller bad, should be replaced. If the resistance of less than 27K, it shall disconnect any two lines in a way, through the series resistance of the resistance to 27K to 28K.
Symptoms: compressor work, but not refrigeration. ??Reasons: refrigeration fluid leakage or two solenoid valve damage is not tightly closed. ????????Solution: leak after trap plus cooling liquid or replace solenoid valve
