Why does the pulley cause fever
The belt tightening is not enough, sometimes it slides and the friction heats up. Solution: adjust the tension wheel so that the tension is sufficient. No oil on the surface of the pulley.
1, belongs to friction drive belt transmission, heat transmission process belongs to the normal phenomenon, but there is a range of fever, beyond this range is not reasonable (normal face 60 ~ 80 degrees). 2, the fever exceeds 60 ~ 80 degrees, the main slippage is caused by, please look for the following reasons: A, the tension in the belt is not smooth. (the tension can also cause the movement to be slower and the belt beats.) B) the power of the belt is not enough to cause the skid to slip (note that the belt installation process has been damaged/damaged).
The high tension of C and belt causes the bearing load to increase, and the heat transfer from the bearing to the belt wheel. D, the pulley is too small for the heat to go away. E, the speed is too high (the highest recommendation is not over 35 m/s) The F and the two wheels are not parallel, and the belt is caused by the grinding of the wheel to produce heat.
