This is what it is doing- the actual pump that is in its own little shed CLICKS all of the time water is being ran, even a small amount of water. The water pressure goes to a slow trickle and eventually stops completely. After about 20-30 minutes I go back and check the spickets and the water is fine, but quickly repeats this same cycle. We just installed this pump about 3 weeks ago. It was doing fine until last week. Does it need to be primed or pressure switch settings increased or decreased? Or am I talking totally out of my head?!
Its either faulty, or was installed wrong.
Might be air in the water lines. Be careful and don't allow the pump to run very long when it isn't pumping any water or you will be buying another pump. It sounds like it is loosing it's prime as it builds up enough to send water to the faucets and then looses it's prime and then has to wait until it builds up enough to start over again. You may need to call someone out and have them run down the problem before you burn up your new pump.
