Is it supposed to take power at the headlight? Open the lamp after the lamp, found blue and white three lines, do not know how to distinguish between positive and negative? There are posts on the Internet that the three lines of the headlamps regardless of positive and negative. If that is the case, the electric handle of the positive and negative lines should be inserted? Note: the car is phantom 150; handle is Shirong electric hand more
Motorcycle electric hand installation method is as follows: 1, depends on the electric hand to the power of the number of small is possible, the premise is best not in the case of headlights, that is the best use during the day; 2, is the feeling It is not cold on the off, so that the battery will get a good charge storage, the general should also be replaced on the board (the handlebar that was triangular parts); 3, split hand models equipped with the former shock, Generally more than ordinary steel car handle models used to cushion a little longer, if not for the shock, may cause the front to become low.
The right hand to remove the right hand to the left hand more easily, just remove the right hand to the combination switch cover, the throttle pull the head and the throttle handle can be separated from the end out. After the completion of the assembly, open the headlamp pig's head shell, the left and right hand to the same color wire docking, because the manufacturers have a good share of male and female joints, would like to insert the wrong is impossible. Will be the right hand to the more of the two lines (black and red) in the package within the black and red short-term plug, and finally the black / red two short-term off the other end of about one centimeter insulation skin, red short-term access to electric locks After the 9P socket in the black positive power cord, black short-term access to the electric lock after the 9P socket in the green line, the key to open the door lock, open the left handle of the electric handle, power indicator light, close the door lock, Electric handle the power indicator light off, indicating that the wiring is correct. Start the engine, open the electric handle switch, about a minute or so, feeling the hands began to gradually heat, the right hand to heat faster than the left hand, do not know whether the product design so? Finally in situ test vehicle lights everything is normal and correct. End the installation.
Headlights of the blue line is the low beam, the white line is the high beam, the green line is playing wire, electric handle the positive and negative lines can not be connected to the headlights, it is best to link the positive and negative batteries, Then connect a switch to the positive terminal.
