Absolutely. There isn't a big problem with that. As long as your amp is rated to handle the lower ohm speaker load, and assuming than the frequency response of the two drivers are in different ranges. You might want to use/make a crossover if their frequency responses overlap a lot. A driver only uses power from the speaker signal within it's frequency response range. So two identical 8 ohm speakers connected in parallel puts a 4 ohm load on the amp. However, a woofer and a tweeter both rated at 8 ohms connected in parallel only put an 8 ohm load on the amp, because the tweeter does not provide a circuit for signals below a certain frequency, and woofer above.
now and lower back this might paintings ok yet often what happens is that the audio equipment will conflict with one yet another at particular frequencies.this might muddy the sound at those frequencies and additionally reason intermodulation distortion at different frequencies the value and output of the countless drivers in contact will fluctuate and is uncontroled this is why pass-overs are used and why audio equipment that have better crossovers often sound betterthere are various aspects that result speaker sound or perhaps speaker manufactures that make extreme high quality audio equipment are no longer waiting to restoration or perhaps evaluate each and all of the themes in contact jointly as designing a crossover and audio equipmentit would sound happy with some song like including a small quantity of reverb or echo might and upload a desirable result however the words interior the songs could be harder to comprehend this will additionally be actual for living house theater the place the communicate interior the action picture would be much less intelligible.
Hi. Not normally recommended. But speakers connected in series will increase resistance and speakers in parallel will decrease resistance. ie Two 3 ohm in series will give 6 ohms resistance. ie Two 3 ohm in parallel will give 1.5 ohms resistance.
