would the wiring harness on a 1.8 acura integra engine fit a 1.6 honda civic harness?
No, but there are adapters you can get to make the engine wiring harness from an acura engine fit a Honda wiring harness. It plugs in at the fire wall. They are a specialty kit and are expensive though (Painless wiring harness). That is if you are trying to put an Acure engine in a Honda. If you are just trying to get a new wiring harness for the Honda go to a junk yard and get one off of a similar Honda.
Yes.. As long as its an OBD0 to OBD0, OBD1 to OBD1, OBD2 to OBD2 and if it Vtec or non Vtec. If you try to swap an OBD1 to OBD2 don't work, and vise versa, If both are OBD2 and are both Vtec. yea it will work, you'll just have a couple of wire left if you use the harness from a 1.8 Vtec.
no u will need to change harness and computer and sensors
i've got not got the coolest comparable form jeep, even even with the shown fact that it particularly is terrific to attempt the wreckers, they continuously have spare areas, in the event that they have not got it, then ring Jeep up and ask them in the event that they have a spare one, there low fee.
