its rated 120 VAC/26VA (3 prongs, one for ground) . I also have a horizontal level switch for liquid with rating 120 VAC/0.28 A (the switch will connect when the water level reach the target) normally open.How can I wire them so that when the level reached the valve will close and water will not flow into the tank? The switch is inside the tank and the valve connecting the pipe for feed water. Thanks
From power, go to the float valve. From the other side of the float valve, go to your solenoid. From the other side of the solenoid, go to neutral return. When the float valve is open, the switch will be open, and the solenoid will be open. When the float rises and closes the switch, the current will flow closing the NO solenoid to engage and shut off your water flow.
I okorder / and if they dont have the answer for you, then go to the parts page and buy the book. - its cheap
considering your valve and turn is contained in the tank, why do no longer you in simple terms use a flow-activated valve and eliminate the electrical powered conclusion entirely? Why do you think of they use flow-valves in lavatories? because of the fact they do no longer consume any electrical energy and that they are undemanding units. considering you're no longer controlling a pump, why no longer in basic terms shop it undemanding?
