With gypsum ceiling, in the dining room to install ceiling fan lights, how to reserve the location?
To install the program you yourself to estimate: Ceiling fan installation program First, fixed lifting: ① wood ceiling, the fixed seat and hanging frame directly with wood screws drilling in the wooden side: "angle Aberdeen" on. ② If the concrete ceiling, then drill with a drill, the expansion screw (gecko) fixed in the ceiling cabinet, and then fixed seat and hanging frame installed up. 1, according to different materials of the ceiling, the use of different screws fixed hanger. 2, please do not put the hanging frame directly on the ceiling splint, to prevent the wood screw loose, bring danger. 3, hanger fixed, must be determined to withstand more than 30 kg of weight (hand test pull) to safety. Second, the installation of pipe, hanging bell: ※ use pipe 1, according to the ceiling height selection of the appropriate length of the pipe. 2, the appropriate length of the pipe for the ceiling to the ground height reduced to 81/2 foot ceiling fan body to the ground height can not be less than 2.5 meters 3, the ceiling fan with a length of 6 "long if not use, please contact the company Buy 4 ", 12", 18 ", 24", 36 "long pipe installation. ※ pipe fixed to the connector 1, the pipe into the dull clock, and then the power cord into the pipe. 2, the pipe into the connector, and insert the coupling bolt and safety pin, then the screws locked. Third, the installation of leaves, leaf frame: (the program can also be completed after the completion of the fifth program) 1, the blade fixed screw first penetrate the blade fixed Huasheng. 2, then the leaves fixed on the leaf frame. 3, fixed leaf frame in the motor surface Fourth, the installation of lobes in the hanger: 1, the ball into the hanger 2, turn the boom, so that the ball groove and hanger lug meshing. ※ ※ The pitch groove must be engaged with the hanger lug.
Connect the power cord: 1. Connect the ceiling fan outlet cable and the power cord with the terminal. 2, the power supply negative (-) line ceiling fan white line, power positive (+) line connected ceiling fan black line. 3, ceiling fan blue line for the light line and ceiling fan should be connected to the black line of positive power (+) line: or wall switch to separate control lights. Six, the installation of hanging clock: 1, the first hanger on both sides of the hanging bell fixed screw out 2-3 teeth, without complete exit. 2, as shown in the direction of the arrow in the direction of the arrow will be the clock on the screw and the right to the right to rotate to the fixed point (the left), and then screwdriver locking screw to complete the fixed bell. Figure 7, switch switch: 1, pull-type switch control ceiling fan high, medium and low three speed. 2, forward and reverse switch control blade rotation direction. 3, the blade counterclockwise rotation when the wind blows down for hot days or with the use of cold air; leaf counterclockwise rotation when the wind blow down for cold or with the use of heating, and can be used as indoor air conditioning convection role. 4, power if the ceiling fan does not turn, please pull the pull switch, or forward and reverse switch. 5, reversing switch can not be cut in the middle, should be cut to the top or bottom. The ceiling fan will not rotate when it is in the middle.
