Woodworking engraving machines, engraving materials, several fixed methods?
For plastic carving patterns, the tape can be pasted on the back engraved object, then the liquid glue affixed with adhesive tape side spray, and then affixed to a void on the surface, it can avoid the use of glue, and left to clean surfaces. Because the tape is easy to strip and clean. Using a specially carved band, the tape is stronger than the other side so that the plates can be moved or replaced at will.
Carved are under pressure if large, consider whether you should use the nose cone of a knife, if the engraving machine diamond knife head carved in moving when the pressure is too large, the pressure will cause tool side carved moving objects. If you use the incorrect diamond knife, it will lead to the same problem. A 90 or 100 degree diamond knife will go deep into the material and allow the material to be moved during the engraving.
For the irregular shape of the sculpture, the surface has been fixed tight, and when it is under pressure, it will shake back and forth. At this point, you can try to put some waste under the object to increase friction. The other is to keep items with packaging, while objects are irregular in shape, but the the packaging may be very regular, and is easy to be fixed, plus a small strap, it is easy to the irregular shape of the object is fixed. Or try a tool to fix its regular parts and discard its irregular parts.
Check the engraving of the choice of pliers or clip head is wrong, at the same time, engraving machine pliers or clip head wear will also lead to the dislocation of the engraving. If the pliers or clamping head is too tight, the contact of the cutter head at the moment of the engraving will cause the sculpture to pop out.
The engraving machines are often equipped with multifunctional pliers or a clamping head, which is made of iron, it is easy to cause injury or carved in the sculpture during the fall, then choose some rubber cap or rubber tube for fixing will be carving help.
