Home > categories > Machinery & Equipment > Wood Lathe > Woodworking gong machine how to use?
Question:

Woodworking gong machine how to use?

Woodworking gong machine how to use?

Answer:

Operation procedure:1. turn on the three-phase power supply.2. connect the grounding wire, make sure the grounding wire is good.3. turn on the machine source switch.4., machine tool running, check the direction of rotation of the tool is correct, all parts running is normal.5. test machine.6. adjust the machine tools according to their own needs.7. after adjustment, the workpiece will be placed on the work table to complete the operation.8. in the process of processing, if there is any difference, please stop the inspection immediately.9. the operator may leave the machine after the machine has stopped and cut off the power supply.
Operation notes:1. operators should be trained and qualified to master the operating essentials of the machine tools.2. when the machine tool is being repaired or not used, please cut off the main power supply.3., often to keep the machine clean and lubrication, before starting the machine to check whether there are wrenches, screws and other foreign objects, will be clearBe clean. Check whether the tool, spindle, lifting handwheel, plate and so on are locked so that they work under normal conditions to ensure safety.4., the use of special-shaped blade, the blade of the amount of extension, compaction degree, balance status, etc., should strictly meet the safety requirements.5., should focus on the operation, a firm body.6. machine tools should be handled by special personnel. Non operating personnel are strictly forbidden to touch switches, cutting tools, etc., so as to avoid accidents.7. suitable jigs should be used when milling small workpieces.8. when the spindle reaches the rated speed, milling can be carried out.9. machine tool spindle jacket, lifting screw and other moving parts should be regularly filled with lubricating oil to maintain lubrication, the machine spindle is high speedRotating parts, the main shaft bearings in the assembly has been filled with appropriate advanced grease, through the prescribed time running test, in line with technical requirements.
Safety regulations:1. before you operate this machine, please read the product manual in detail. Check whether the grounding wire is firm and all parts are normal.Is the operating position bright and without shadows?. Caution: the operator must undergo rigorous training and read the safe operating procedures in order to operate2. woodworking milling machine is a high speed machine tools, before use, must undergo strict inspection, to ensure good dynamic balance performance. But in makingIn the process, if the dynamic balance of the parts is changed, the maximum vibration may be caused, and the long time vibration causes serious mechanical fatigue, thus accelerating the damage of the parts and causing the accident.3., operation should be three tight, three no, one attention. Three tight: clothing tight, tight waist, tight shaft; three no: no tie,No hand or no gloves; one note: watch your eyes.4. before starting the machine tools, please pay attention to the warning signs on the machine tools.5. check the spindle and tool rotation direction.6. during operation, do not touch or move parts near or touching; do not remove debris, adjust machine tools or remove debrisThe power must be cut off before the cutter shaft stops turning completely.7. after the tool has been blunted, please replace or grind it in time.8. do not exceed the scope of machine tools to prevent unsafe or damage to machine tools.9. if there is any difference, stop the inspection immediately.10. when the operator leaves the machine or the power failure, the power master switch must be switched off.11. the machine must be completely shut down before the operator can leave.

Share to: