Woodworking lathe double knife Lita good or good
Due to the biaxial baiting complex, positioning and other factors, speed and real effect we have seen is not faster than us (especially more than 6 cm above the edge of the column from the center set of processing speed of processing them is at least half of biaxial slower than us.) So we have seen many customers who use the double axle lathe, because of this reason, we bought the double axle and only used single axle. Achieve true speed and effectiveness. Or do you want to look at them personally and compare them in actual machining.
Fixed center material: center support our weight placed on the bracket using timber naturalcondition center, and only by the side axis bracket, hand hold, then hand strength is not the same as the center will make the positioning column, central location will not directly affect the processing effect.
The difference between the two axis and double knife, 1. manual programming is not standard, with my understanding, the two axis is segmented manual programming, we are programming software automatically generated. Accurate to one percent millimeters, accurate, and fast. The computer can generate more intuitive columnar, cut can be arbitrarily measured, modified size. 2., processing speed: the center of our lathe sets can be done within 10 cm side of the size, so the processing of these pillars faster, jitter small, smooth finish. Biaxial that lathe, as far as I know, due to the distance between the two axes, the central set size can only be done side about 6 cm, the side is greater than 6 cm, there is no central set available. Therefore, the processing speed is slow, the effect is not good. The 3. column of the large wooden car adopts double layered knife turning, two knives in the axial distance of 1 cm between the total turning depth we are divided according to the specified proportion, so greatly reduces the cutting intensity of each knife. To avoid the vibration generated by the knife knife. (because the knife is the most difficult to grind, and two knives) due to produce turning force of column in the column two, beat so the column were much reduced, increased wood finish.
The double axle heightening tool holder and the heightening headstock reduce the stability. Because the turret and headstock are below, the turning point is farther away from the fulcrum, and the stability is worse.
