Home > categories > Machinery & Equipment > Bending Machinery > Yang Li bending machine problems please experts advise!
Question:

Yang Li bending machine problems please experts advise!

Yang Li bending machine problems please experts advise!

Answer:

I side of the pressure on the side of the two reasons is not the same as the side of the hydraulic cylinder into the oil pipe a little oil, do not know if you have any oil spill, feel Yang Li's bed into the tubing seal ring,
), Turn the side of the belt, to the side of the pressure or decompression adjustment, the direction of a few small board with a try to know.
2 side angle is not the same as our factory also out of this problem, I have climbed to the bed above the adjustment of the Y's transmission rods loose (loose near the belt that hexagon screws, a small tube and the same transmission rods on the line
That bed is not a numerical control of it, it is estimated that the lower die, the bottom of the slider that you set a high, in the bed on the right side of the tank that can be adjusted up and down the trip, the following is to adjust the bottom dead center,

Share to: