I am very grateful to you, thank you for your answer, recently received a set of automatic doors, automatic doors are beautiful and resistant to 90 type, the customer asked me to automatically Door to install the access control controller, that is, the door with a password and card to control the door, go out with the door button to open the door, how do I use the blog Q2006 access control and electric locks to control the automatic door to open the door and closed after the lock ah, Automatic doors do not lock can push hard ah. This is not safe ah. Who can tell me how heroes wiring, thank you, ah ,,, in this wish you work smoothly, love sweet and dense. The The controller above the Q2006 access control controller and electric lock to control the automatic door to open the door and close the door after the lock ah, the controller has OPEN GND GND PUSH +12 V 5 lines, such as access to the lock is what the automatic door signal Open the door
The principle is the same. Are the doors that are received after the signal is turned on or off. But the automatic door is received by the infrared detector signal to open the door, and the access controller is to receive the card reader signal to open the door. So, wiring is not complicated.
Look at your automatic door is how to control, whether with the controller, the controller output voltage signal or on-off signal, the voltage signal directly to the lock, on-off signal will need to string into the DC12V power supply, you put the brand I did not Used, but I have this Heide Borg automatic door machine, it with the controller, the direct lock can be, access control controller as long as the door controller to a normally open signal on the OK
