Home > categories > Electrical Equipment & Supplies > Fuse Components > Electrical problems on bike?
Question:

Electrical problems on bike?

Hi, I've had a lot of problems with my bike and I know I need a new one. Don't need to be told that. I own a 2005 R50x 50cc scooter. On my way home, the lights went off and the 'dash' went off including the rpm gauge. The horn, starter and full beam still work though. The fuse is fine and it isn't the battery. If anyone has a clue please let me know and the location of the components that may be affected. FYI, all the electrical bits are in the front not under the seat. Many thanks

Answer:

Without a wiring diagram, I can only speculate. The ignition switch might have a seperate circuit for the items not working. Using a test light, check for batterry voltage at each component. Trace each wire back to a wire they all have in common. Figure out why that wire isn't getting power.
make confident the two events are not basically coincedence. because of the fact the different adult adult males stated, with the ignition change off, there could desire to be no juice going to any of the lighting fixtures fixtures. With the change off, the only place wires would be energized is between the starter soleniod and the change. i'm doubting that's a shorted cord on the grounds that could in very almost all likelyhood blow the top-rated fuse. If the fuse did not go, you may fry the shorted cord and at perfect you have got a melted wiring harness or at worst a charred bike. i've got had shorted wires and that i'm speaking from journey on that count. If this subject happens returned, i could verify the ignition changeperchance squirt somewhat WD-40 down the keyhole.
it sounds like the side light fuse, but could be the earth wire to the lights,check earth connections, quick test get a piece of wire hold it to neg - on battery or bare metal on frame with ignition lights on touch the other end to side of the bulb if light comes on its a bad earth

Share to: