How do you use PROE to rotate the stairs?
Use the array command to get the rotation of the stairs, but in drawing the basic features to pay attention to the size of the marked position, because the basic characteristics of the size of the array when the drive size!
Need to use rotation and array.
Look at the picture, first turn a step. Remember to mark size 0.
After the rotation see below
Then point the axis array, click the size, enter the number of arrays, increments to step height, or other values.
The array is shown in the figure below.
Rotation of the staircase, the use of sketches, drawing tools, the use of features in the operation of the copy rotation, array and other functions, learning this tutorial allows you to more skilled use of proe.
1. Go to sketch to draw the following sketch
2. Stretch out the cylinder as shown below and make sure
3. Draw two centerlines, each side of the folder 9 degrees, and draw the following section
4. Stretch out a staircase
5. Copy (which is entered in the characteristic operation) Move --- Rotate (At this point it is important to note that the selected curve is the one, the center is the center axis)
?
?
6. Array, pay attention to the use of size arrays
? Size array Select a size, it is in the X and Z: Y and Z axis changes, select the two sizes, then the X and Y axis changes
?
?
? Through the operation of the feature copy, the size of the array size selection in the original copy of the basis of regular changes, the same size to select multiple sizes:
Select the center of the two objects will shift the volume of the same volume, the location gradually move,
Select the size is not the size of the offset, the parts will gradually increase the volume
