What is the installation process of the sand recovery machine? Is it difficult to install?
1, the equipment arrived at the scene, the user according to the list of goods inventory check and acceptance.2, first wash trough placed in the pre watering concrete foundation, according to groove steel above looking for level, require four points error + 2mm.3. Install the vibrating screen. When the four support beams are loaded on the spring support, the spacing should be basically equal. The bearings should be parallel to each other. The rubber spring and the ground plane should be vertical, tighten the clamp bolts and connect the motor wires.4. Vacuum high pressure pump is installed. The vacuum high-pressure pump is installed on the foundation, and the base is leveled with the ground. The pump is equipped with valves, water inlet and washing tank at the front of the pump, and the water outlet pipe shall be aligned and welded firmly. No water leakage is allowed. The two times of grouting after the foundation is dry and solid, the fastening bolts shall be fastened. The motor should first connect the power cord, test the direction of rotation, and vacuum high-pressure pump in line with the direction, and then with the flange docking, after looking for positive, and then tighten the motor anchor bolts. The pump is not operating under empty load.
Fine sand recovery device is advanced technology of long Luoyang abroad, combined with China's scene habits and design of a high efficient sediment recycling equipment. The equipment overcomes the difficult problems of sand washing and dewatering in the traditional process, such as sand washing machine, fine sand material loss and difficult control. The fine sand recovery device can effectively reduce the loss of fine sand and reduce the stone powder content in the tail water. It can solve the difficult problem of the high fineness of the finished sand and the low content of stone powder in the artificial aggregate processing system. Now let's show you how to install the sand recovery device properly.
High pressure separator: steel bearings will return bend and outlet docking will be installed in the high-pressure separator feed back on the box, the lower end is inserted into the pipe back to the material box and the upper cover plate and welding, sand recycling equipment high pressure separator the front end of the feed box, loading and fastening bolt. Fill the 76mm feeding rubber tube, the lower end is connected with the pump outlet pipe and tightened with wire.
