I need to know about the fuseable link. and or wiring diagrams.
fuseable link . power to coil when cranking motor 12 volt
need a starter wiring diagram.it would be in a haynes repair manual.the fuse link red wire will be on the starter solenoid positive wire to starter solenoid .
depending on how it was set up to the solenoid, you could have two or three wires, including the battery cable. that large wire goes from the b terminal on the starter to the battery positive. there is also an i terminal on some, that is a wire that goes from that terminal to the ignition coil indirectly for a full 12 volts or close to it while cranking. the last terminal should be the s terminal. it goes back to the ignition switch.if you only get a single solid click, i think the solenoid is a good potential for the problem. if you pull that off and remove the plastic cover at one end, you will find the moving contact section. either flip that copper piece around or use a fine file or sand paper to clean it up along with the contacts in the cap itself. after all of that is clean, reassemble and bench test it before you reinstall it. if it cranks over well and at high enough a speed, then install it. if not, check the battery and then maybe have the starter tested at a shop. if you reinstall it and it still only gives you a solid click, then see if you can crank the engine over with a socket on the crank. bolt. if that does not work, then pull all of the plugs and try again.
fuse able links are at starter on battery + terminal they come down back of motor and threw a heat shield i think 2 maybe 3 wires all red starter wires is purple no fuse link on purple only reds
