Advantages and disadvantages of solid wood flooring
Foot: solid wood flooring and solid wood flooring are made of wood, feeling is the same, and strengthen the floor due to the different tectonic Juegan become more blunt (two feet on the customer laminate flooring and solid wood floor, can clearly feel the difference between them). Note that the solid wood floor surface is a layer of UV thick paint, human exposure is only UV paint instead of wood itself; paint multi-layer solid wood flooring is paint penetrated into the pores of wood fiber through the penetration of advanced technology, the human body is exposed to a mixture of paint and wood. Therefore, the multi-layer solid wood floor has the characteristics of cool in summer and warm in winter, which is not the performance of other flooring materials. Can let the customer put two hands on the multi-layer solid wood floor and other floors, you can immediately feel the obvious difference between them.
Abrasion resistance: the national standard for multi-layer solid wood floor wear resistance test standard for 500 Newton positive pressure to turn to 100 when the wear quality is not more than 0.08 mg. Multi layer solid wood floor paint is generally used in UV paint, the surface coated with a layer of ceramic powder and its wear resistance is sufficient to strengthen the floor with three oxidation comparable to aluminum two. For example: in Higa Higa multi-layer solid wood flooring using imported advanced ultra wear green UV resin paint (PPG), to produce the floor with good wear resistance, scratch, scratch resistance, compressive. Then through the 9 surface of the top of the 2 (UV drying equipment curing) special paint surface treatment process, to improve the quality of the paint surface
Stability: solid wood floor of its wood fiber unidirectional and tree core and tree edge of the tree age is different, resulting in different levels of wood density of wood, so the plate caused by the thermal expansion coefficient is different and easy to deformation. In the case of dehydration easy to sew. Strengthen the production process of the floor is wood waste processing into powder, add glue, pressed into high density plate under high temperature and pressure, and then paste the computer printing decorative paper, then coated with three two aluminum oxide coatings and wear resistant materials, finally processed into what we see shape. Strengthening plate stability is good, but because of its substrate is high density board, heat and moisture to the whole swell, if left in the installation of the contraction joints of small, easily arching, and the floor is afraid of water, water easily after expansion, not a good deal. Multi layer solid wood floor, the production process is to cut wood veneer, and then according to the wood grain crisscross with resin glue hot pressing molding. Because the structure is arranged in a crisscross pattern characteristics between the layers contain each other, so as to overcome the above wood heat expansion coefficient of eighty-five percent, the deformation is small, and the substrate core board is the selection of Eucalyptus wood is loose, the pores of wood between the loose stress can also be partially offset by an expansion of wood shrink. So its stability is much stronger than other floors.
