Home > categories > Machinery & Equipment > Forklifts > After the forklift is killed, it will stall!
Question:

After the forklift is killed, it will stall!

After the forklift is killed, it will stall!

Answer:

Domestic forklift would ', that can not, there is nothing wrong with the car, I didn't see any domestic had such a situation, or diesel pump is broken, lead to the low idle speed, low (but the oil pump is normal, idle will not necessarily shut down), or steering cylinder oil seal is damaged, steering on each bearing damage, often do not beat butter, causing friction is too large, resulting in the stress, remove from heat. It is recommended to be repaired on all parts, more butter, high idle, or school oil pump
Any mechanical direction killing will cause damage to the direction system! You're holding the engine out!
Improper operation, it is ok to follow these steps: forklift safety operation procedures (a), check the vehicle 1. Forklift truck before and after operation, should check the appearance, loaded with fuel, lubricating oil and cooling water. Check for starting, running and braking performance. Check the lighting and sound signal to be fully available. The forklift should check the pressure and the temperature is normal. The forklift should also check the leak and replace the sealing parts in time. (2) starting from the beginning, before starting, after observing the perimeter, confirming that there are no barriers to the safety of the road, the first start of the whistle. The vehicle of pneumatic brake, the reading of the brake barometer must reach the specified value before starting. The driver of a forklift should first confirm the steady and reliable delivery of the cargo. The safety operating procedure of forklift truck (1), check the vehicle 1. Before and after the forklift truck, should inspect the appearance, add the fuel, the lubricating oil and the cooling water. Check for starting, running and braking performance. Check the lighting and sound signal to be fully available. The forklift should check the pressure and the temperature is normal. The forklift should also check the leak and replace the sealing parts in time. (2) starting from the beginning, before starting, after observing the perimeter, confirming that there are no barriers to the safety of the road, the first start of the whistle. The vehicle of pneumatic brake, the reading of the brake barometer must reach the specified value before starting.
Not only the forklift, all motor vehicles, as long as killed, throttle behind will be shut down, many novice will make such a mistake, because your direction after death, the resistance is very big, after driving wheel push, front wheel walk sideways, had been suffocated. There's nothing wrong with the quality of the car. Don't worry about it. I've been doing car sales for more than a year
The steering pressure is too high. 2, it's normal to hold off the fire.

Share to: