After wireless relay, network speed is slow, bandwidth is reduced, how to solve?
Of course, it is possible to run at full speed if the bandwidth between the routers is large and the quality of the signal between the two routers is good. However, in this case, the distance between the two routers should be relatively close, and the antennas should be kept perpendicular to the ground. The best route of sight propagation between the two antennas is guaranteed.
Because of the overhead of 802.11, only about half of the bandwidth can be used for data transmission. Because of the repeater, bandwidth is once again divided into two halves, especially when multiple users share the same channel, and thus you experience bandwidth problems.The best solution is to connect the route and the relay directly with the network cable. By wireless connection, you have to pay for the loss of bandwidth.
This is normal. After the relay, the bandwidth is halved.The repeater must receive and forward frames on the same channel, which means that your bandwidth is actually split in two. Although the scope is more important than bandwidth, the rate of transmission over the remote client will be as low as 1Mbps.
