All-steel ceramic anti-static floor. How can you open the hole? Used to take the line. What tools can I open the hole at once? Question added: .. both brick and brick but also ceramic tiles have not? To open the hole, what turned around? More
The pistol is drilled with a diamond drill and can be drilled out of the hole. This is the case, to say in detail. If it is on the wall, as long as the wall in the open slot on the line, do not need to cut on the floor so much trouble. Piston drill (Note! Not the impact drill!) The impact of the force than the portable cutting machine much smaller, only saw the cutting machine will be cut off the floor, have not heard of pistol drill to drill floor drill. In the case of a general site construction, the worker can drill the hole into the hole with a pistol. You can also go to the metal processing plant (angle iron processing or aluminum alloy doors and windows processing plant) with industrial bench drill, with a diamond drill bit will be able to drill holes, but also to the floor to spend more money, more trouble. I'm not going to sell ads, it is downloaded from the Internet pictures. Buy 3cm aperture drill to use, to buy some good points, do not even a hole did not drill on the rotten.
Although the tile is beautiful, but to punch on the tile is not an easy thing. Because the tile itself is easy to bad plus a hole is easier to break along the gap. Method / Step 1 ? The position to be punched is pre-calibrated to ensure the level. (Note that the corresponding location of the wall do not have water and electricity lines) 2, with a glass drill hole in the ceramic tile, the first tilt direction to play a pit; otherwise the tile is too smooth and bad positioning; or not all tiles, with nails directly A small pit to come; think about precision, you can also have a hole (size appropriate) plate with the best. 3, set out to play a small mark can remove the positioning of the orifice, and then. Prepare a bottle in advance, drill a hole in the bottle, the bottle filled with water. Then, when the hole to the water at the same time to the drill bit and tile contact parts; especially the whole tile, be sure to have water Oh. 4, there is no need to change the impact of the drill. Open the tile part, continue to play the screw depth. Attention to play a hole, remove the glass drill, the blocked part of the drill bit to clear the hollow. (All the tiles in particular to do this step).
Network cable buried under the wall and then how to open the floor?
Generally with cutting machine (also known as marble machine) or drill open, if it is open square hole, with the cutting machine can be opened, the general mud workers have, need to cut the two knives, because the floor is relatively thick ( 4 cm). If you want to open a hole, it is best to use a drill drill, bench drill only in specialized drilling only where there is. It is recommended to open into a square hole, and the best open on the edge of the floor, so even if the floor is broken, the replacement is also convenient. Cutting machine can cut tiles and cut steel. Ordinary steel floor (melamine surface layer) can be hand drill with diamond drill bit openings, but the ceramic surface full steel floor open hole can only use the bench drill, because the intensity of hand drill is not enough, it is easy to drill the surface of the tile The
