OK, where can I get the shaker dust collector?
Operation characteristics of vibrating screen dust collector1. Dust collector is not covered.2, power consumption is small, operation and management cost is low.3, dust pulse blowing, ash cleaning by PLC automatic control, stable and reliable.4, the most applicable coal, sinter, ore and other raw materials vibration sieve system dust removal.5, one-time investment is small, compared with other dust collector, running 2 months, recover the cost of investment.6, according to the nature of the material, the temperature, choose different materials of filter material, to ensure the dust removal effect and service life.7. The dust collected by the vibration sieve dust collector is directly returned to the bin or the belt without two pollution, thus saving manpower and material resources and effectively recovering raw materials.8, high purification efficiency, in line with the state environmental protection index requirements, and thoroughly solve the vibration screen dust pollution problems.Characteristics of dust cleaning of vibrating screen dust collector1 、 pulse off-line cleaning, the efficiency is higher than 99.9%, dust does not produce two adsorption;2 、 the air pressure is only 0.2 and 0.3Mpa, and the filter bag and pulse valve have long service life;3. Deal with high temperature, high humidity gas, and filter wind speed up to 1.2m/min4 、 the filter bag is easy to assemble and disassemble with good tightness;5 、 electronic control PLC automatic control, easy to operate, reliable performance;6 、 new FMS microporous composite filter material, suitable for all kinds of smoke conditions, the service life of more than 3 years;7, small footprint, low investment, good results.
The device consists of dust catcher, fan, pLc automatic pulse blowing system, hanger, inspection door, sealing soft curtain and so on. The use of vibrating screen dust collector can avoid the dust flying everywhere and pollute the environment, and contribute a lot to the protection of the earth environment. With the increase of the surface of the filter bag dust, knife resistance value reaches a predetermined value, the pressure sensor to the electronic control box indicating signal, by pLc automatic control system for automatic pulse jet bag was blowing, attached to the bag on the dust shake off, after unloading ash pipe directly to the sealing belt. That is to keep the filter bag good filter performance, and no two dust.
The vibration screen dust remover is a MC pulse bag filter, which is specially used for dust producing in the vibrating screen. Because of the font difference, some people call it shock screen dust collector.
