Aluminum buckle ceiling ceiling how to do
The card into the place to get closer, or the edge of the aluminum plate bent a little bit after the card into the just fine, you try
This depends on the type of ceiling board to choose the appropriate solution. Specifically, it is divided into the following two cases:
1, the ceiling of the board for the square board (the general specifications in the 30 cm or so square), first remove the ceiling next to a square plate, using a wallpaper knife blade into the ceiling lamp and the surrounding square between the gap of a certain size And then the blade will pry the square around the ceiling lamp and then take the board from the side of the side where the board has just been leveraged. After the ceiling of the connection to the wire to be replaced after the replacement of ceiling lights. To be finished after the lamp, and then re-install the square board can be removed just.
2, the ceiling of the board for the board (that is, long strip), to remove the ceiling lamp, you need to ceiling lights on both sides of the strip on both sides of the buckle first removed, and then take the board and change the lights.