Are flanges and bushings the same thing?
The flange plate is connected; the axle sleeve is fixed and positioned
The flange is the part that connects the pipe to the pipe and is connected to the end of the pipe. There are holes in the flange, the bolts make the two flanges tightly connected. The whole cylindrical bush is called the axle sleeve. The shaft sleeve and the bush are equal to the outer ring of the sliding bearing, the shaft sleeve is integral, and the bearing bush is split. Jiaxing Solid Bearing Co., Ltd. is specializing in the production of self-lubricating bushings and Oil Free Bushings of professional manufacturers.
Flanges and bushings are not the same thing.Turn left and turn right |Flanges (Flange), also called flanges, flanges, or flanges. A flange is a part that is connected between the pipe and the pipe, used for the connection between the ends of the pipe. It is also used for the flange on the entrance and exit of the equipment. It is used for the connection between the two devices, such as the reducer flange. Flange connection or flange joint means that the flange, the shim and the bolt are mutually connected as a group of three detachable sealing structures. Pipe flanges are flanges used for piping in pipe installations. They are used on equipment and refer to the entrance and exit flanges of the equipment. The flange is lined with bolts to secure the two flanges. Gaskets for gaskets between flanges. Sub threaded flange connection (threaded connection), flange welding flange and flange clamp. Flanges are used in pairs. Low pressure pipes can be made of wire flanges and welded flanges with pressures of more than four kilograms. Add a gasket between the two flanges and secure with bolts. Different pressure flange thickness is different, they use the bolt is also different. Water pump and valve, and in the pipe connection, these equipment parts of the equipment also made corresponding flange shape, also known as flange connection. Any connecting parts that are bolted and closed in the vicinity of the two planes are generally referred to as flanges, such as the connections of the ventilation ducts, which can be called flanges". However, this connection is only part of a device, such as flanges and pumps connected, it is not good to call the water pump flange parts". Relatively small, such as valves, can be called flanges".The sleeve is a cylindrical mechanical part that is attached to the shaft. It is a part of the sliding bearing.Generally speaking, the axle sleeve and the bearing seat adopt the interference fit, and the shaft and the gap fit.
