Ask the following questions: operating procedures for foam cutting machines.
7, dusting line in the cutting before, pay attention to zinc powder explosive, pay attention to avoid flying; at the same time, wear masks when operating.Prepare dry, clean, sheet without large deformation;Determine single cut moments, synchronization or symmetric dashes, and prepare the corresponding cut moments;On the operating panel, select the corresponding car selection button";Select the appropriate cutting nozzle according to the width of the line to be crossed;Bake the zinc powder in the oven at 200 DEG C for 4 hours, then sift the 200 mesh metal powder into the zinc powder bucket;Preheat flame;Adjust the flame as a weak oxidizing flame, the flame length is used for cutting cone length;Open powder supply oxygen, oxygen line, adjust the switch, until the cutting spout is uniform and fine straight orange line so far;The operation panel on the "mode" button to select "line"; out of need to draw graphics; start when a line crossed; if the effect is not ideal, you can press the "Cheng back" button to perform reverse execution procedures, the need to re crossed point, then press "Cheng back" key to the end of the line is crossed; later, in order to close for oxygen, oxygen and scribing powder preheating flame electromagnetic valve closed; powder supply oxygen, oxygen line switch; the remaining zinc recovery, placed in a drying box, zinc powder bucket clean.
Numerical control foam cutting machine due to the use of computer automated operation, the need to pay attention to during the cutting operation with more details, here on Wuhan Yide CNC cutting machine operation with decomposition indicates that the reference to the user:1. Switch the switch in the distribution cabinet;2. Open the power panel on the power panel, press the power button to supply the power to the CNC, switch on the power of the dust collector and check whether the indicator light on the control panel is normal or not;3, CNC for internal self diagnosis, confirm no error information;Switch 4, closed servo cabinet, servo press operation panel on the open button, to the servo system of power supply, control panel on the open position of the rotary knob to the pulse of the recoil on the cartridge, check whether the pulse is normal;5 、 test operation, confirm the switch on the panel, button flexible and reliable, check the ash discharge plate valve is normal;6 、 test the machine, confirm the machine running smoothly, each limit and emergency button is reliable.
8, plasma cutting, we should pay attention to, when automatic ignition, the staff should stay away from ignition high voltage coil;Prepare the plate to be cut, carbon steel, stainless steel, aluminum deformation as small as possible, the thickness shall not exceed the allowable range of the cutting table;According to the thickness of the plate to choose the corresponding parts; and in the corresponding inner cutting torch;Sure, synchronous or symmetric single torch cutting;On the operating panel, select the corresponding car selection button";Press the plasma button on the panel to turn on the light;Perform pre flow and cutting flow testing according to cutting table and adjust pre flow and cut flow;The height of the cutting table to manually adjust the height requirements of the initial cutting torch;Arc pressure current is set according to cutting table;The manual will be set to the starting position of cutting; cutting selected in the CNC program, and complete the work allocation: cutting speed, cutting compensation etc.; according to the "GO" button to start cutting; according to the operating instructions for different problems in cutting, processed, until the complete cut.
