Plastic products to do how to cut, that is, forming a lot of products, how to get down design, cutting fixture?
Design a special cutting clampIf the conditions permit, it is better to change the mold into a shallow gate, which is much easier
If more holes, manual cut, the efficiency can not keep up. According to the product structure to design the cutting fixture, commonly used type is relatively simple. If the mold structure allows, it is best to use the hidden gate, both to ensure that the rubber level, but also artificial.
When the mold structure does not allow the submarine gate, only open the gate design, the product with the gate mold is together, if a multi point manual cut out a small number of completely manual diagonal pliers cut (four to six points.).
