At what price is a cheap performance exhaust system that increases horsepower and Makes deep sound for an rsx?
Any muffler you add to an RSX will make it sound like a can of angry bees. The factory exhaust system on that car is completely adequate unless you start doing performance upgrades to the motor.
For the best answers, search on this site shorturl.im/avXAY Here's a trick I use when I have wrinkled clothing that can't be ironed.I hang the garment in the bathroom close to the shower in an area that won't get wet, then I turn the shower on as hot as it will go. Then I leave the bathroom making sure the door is shut. The steam that the hot water creates always loosens the wrinkles from my clothing.you should try it!
Here is a trick for getting wrinkles out of 100% poly without damaging the fiber. Spritz the wrinkle with water in a squirt bottle. Hang the garment up so that you can access both sides. Use the steam setting on the iron and use the steam burst function holding the iron 6-8 inches from the garment, never touching the iron to the fabric. I can set my iron to the acrylic heat setting and still get the steam bursts. Your other option is to use Downey wrinkle release which you can buy at the discounters and grocery in the laundry aisle.
You have dual exhaust pipes from a Y split at the rear axle not a complete dual exhaust system from the motor back. An exact replacement stainless steel Dynomax Super Turbo would be the easiest least expensive way out. If you were to replace the complete system with headers and individual catalytic converters it would cost nearly $1000. do do it up correctly. It's entirely up to you. Usually a juiced up full (headers included) exhaust system will benefit a blueprinted high performance motor much more than an every day driver.
lay it out on your ironing board. start your iron on a very low setting. you'll work up the heat on your iron until the iron just barely gets the wrinkles out, you'll have to work on it for a while. do NOT turn your iron up on high. The gown will melt. Press hard with your iron on a warm setting. Spraying with water will help a lot.
