The house has been living for two years, these days do not know the weather is wet or how the matter, the bathroom tile actually fell a few pieces, but fortunately did not break. Now want to paste it back, I would like to ask, how to paste? With cement? Or what other glue? Do you want to drink again before There is also a problem with the brick at that time, but the closure or other problems? Another: Tiles are Mona Lisa. Thank you!
If the individual tiles fall off, you can re-use the pure cement paste the tiles, but if it is falling out of the tiles of the wall is not on the original cement cleared, then the cement paste will make this place higher than the original Out of the point, and the removal of the original cement with a certain degree of difficulty, because in this piece of empty space at the four corners of the cement is more difficult to remove, confused will not fall off the tiles broken. There is also a way to: buy a group of "AB resin glue", according to the instructions on the plastic tile in the fall of the reverse, in the paste to the original place, and so about 10 minutes after the initial curing, and so on 24 After hours, it will be a very good sticky. But if you use glue, it must ensure that the wall and the place to be tiled are dry, can not have humidity, otherwise it will stick.
If you want to use the same as the original, it is necessary to use cement mortar paving, they can also use glass glue, but because the glass glue is basically stick a few points, so there will be hollow drums, water will go into the water, Hook the agent is also very necessary Oh.
Building materials store to sell plastic construction, smear to the back of the brick, paste it can be, I used n times.
