Why I use this stuffed by the director scolded, saying that this is not standardized ah more
According to the principle of structural mechanics, filling the top of the wall oblique piling, the principle of force in line with the framework of the theory of the role of the wall under the structure, in comparison with the brick structure, due to the role of brick walls The structure of the brick wall is different from the frame of the filling wall), so the brick and concrete structure of the top of the wall just like the framework of the filling wall is different. . on the construction point of view, this method is more convenient construction. . "Masonry construction quality acceptance norms" GB-2002 Article 9.3.7 provides: fill the wall to close to the beam, the bottom of the board, should leave a certain gap, to be filled with wall masonry and should be at least 7 days after the interval, And then squeeze it up. Because the filling wall masonry is completed, the masonry will produce a certain deformation, improper construction, not only will affect the beam, the bottom of the close combination, but also produce cracks in the joint parts. On the one hand because the inclined brick material is the same as the filling wall material, the problem will not occur mixed, in addition, the slanting can be better squeezed with the beam, the bottom of the gap. Of course, can also be used concrete pouring, but generally do not, because the concrete pouring, then slump is too difficult to fit into the gap, slump is too small is difficult to dense concrete itself, if the gap is relatively large, but also use the template, The So it is not commonly used.
Should be slash ~ ~There are ordinary brick (45 degrees slash), refractory bricks (45 degrees virtual slash), hollow brick (well word + slash), etc., different materials different filling methods ~ ~ such as concrete, reinforced concrete, mortar. Must be closed to open the map, open the BH command to know there are several fill in the form of filling the wall, brick masonry. The frame of the filling wall in the tiles to be inclined for the following reasons: . fill the wall in the top brick masonry is to So that the top of the wall more compact, easy to crack after the plaster, flat puzzle, then the effect is not good, and the construction is not good operation.
You are sure to be the director of the curse of the song, the pattern is filled with the graphics, the correct fill method is to find the CAD inside the pattern fill tool and then find inside the ordinary brick in the fill on the line ,
