Can reaction bonded polymer wet laying waterproof roll be dry paved?
Pulp, pat on the surface of membrane exhaust: Wood trowel or rubber plate, the air discharged below the coil, the coil and the polymer cement-based elastic waterproof coating or cement mortar bond.
Remove the isolation material on the lower surface of the waterproof coil and spread the film on the polymer cement base waterproof coating or cement mortar. Between the coil and the adjacent coil is the parallel overlapping way laying (generally does not use the butt joint waterproof). Seam width shall be no less than 60mm.
Maintenance: after the completion of the laying of the coil, maintenance 48 hours (depending on the temperature of the specific time, in general, the higher the temperature, the shorter the time required). Winding joint and sealing treatment: self sealing strip can be used at the butt joint. When the operation, first of the coil lap parts of the upper surface of the separation membrane (or silicone oil separation paper) to remove, and then stick to self-adhesive tape. If the bonding parts are contaminated, clean them first.
