Can the hydraulic jack be changed?
Personally think that as long as the pressure of the air pump is large enough, of course, the pressure resistance of the hose should be good enough. The speed problem can be solved by the variable diameter joint
Yes, as long as the pressure of the air pump is large enough, of course, the pressure resistance of the hose should be good enough, and the speed problem can be solved by the reducing joint.Test method:1. remove the hydraulic jack refueling refueling Pusey, down on the square on the tin.2. release the hydraulic jack release valve and release the oil.3. remove the lift lever and use the +0 wrench. 8 meters of pipe clockwise unscrew the small pump, using a pointed nose pliers to pry open the gasket, remove the 6# ball.4. hydraulic jacks clamped in a vise, use pipe wrench will cap loosens counterclockwise, remove.5. beat the coat with a leather hammer and take it off.6. pull out piston rod, such as pulling out, put out the base with pointed nose pliers rectangular rubber ring valve hole, pour 8# ball, with a long stretch in the end mouth gun oil discharge valve seat hole inside the air, need to control the volume, the piston rod will pop up, aim at the wall, avoid injuries caused by pop-up.7. remove the nylon seal of the hydraulic jack piston and then put the piston rod back into the cylinder. Use the tubing to clamp the cylinder against the counter clockwise. Thus, when the pipe clamp is pulled on, the deformation of the oil cylinder can be avoided and the clamping flat can be avoided.8., with self tapping screws into the steel ball block, with pliers pull out the block, take out 6# steel ball.9. all parts of the hydraulic jack are cleaned with diesel oil and dried with an air gun. The holes in the base are blown with an air gun, and the inside of the cylinder is observed with a flashlight. Is the inner part of the pump smooth?. Replace it if it is not smooth or damaged. Observe whether the three steel balls are round and smooth.
No, high pressure gas is dangerous, and the output speed and thrust are not stable.
