Home > categories > Construction & Real Estate > Tile > Ceramic tile floor?
Question:

Ceramic tile floor?

Want to put ceramic tile floor down in bathroom. It has a lanolium floor now. What is the best way to prep, in order to have a good tile job.

Answer:

Hi, you need to pull the linoleum up first. Than scrape the loose mastic off the floor, sand it (you don't want an uneven surface) and wipe up the dust and dirt. Than you can start putting down your tiles. Make sure you leave a window open or the smell of the mastic will leave you high as a kite, and you don't want that! Bye
Everything is possible. But depending on the type of tile I would not recommend painting it, especially if it has a glazed finish to it. The only thing that might work would be an epoxy coating they use on garage floors. I know if it was my house I wouldn't want to rip it out and re due the tile, but at the same time I do not think you would be happy with the paint after a few months and it is flaking off or wearing thin in the traffic areas, (that is assuming it will stay on that long). Good luck!
If the floor is concrete, remove the existing floor covering. Use thin-set, not mortar and lay the new tile. Begin in the center of the floor to make sure the borders come out even. Remove the toilet. It makes for an easier job. If the floor is wood, use hardi-backer or wonder board as an underlayment. Then set the tile.
tear the linolium up you should have plywood under there if its plywood you can a couple things. a you could pour a selfleveling compound on, its comes in a bag like concrete and you mix it with water pour it up to an inch thick and tile right over that. b you can lay osb or cement board on top of the plywood which come in 3x5 sheets for about 10 bucks and tile over that. the levelor would run you about $40 for a small bath maybe 75 ft2. the cement board is $10/15ft2 plus mortar $10 and screws $5. if its concrete you can tile over that just make sure its level and a clean smooth surface.
if you have wood sub floor, and is at least one and half inch thick, i would leave lanolium down buy quarter inch ply wood. screw it to floor and get bucket of mastik and install ceramic tile....I've tried it and works great has been down for 5 years and no problems yet. it was in bathroom and kitchen

Share to: