Clean the cleaning parameters of the equipment
Judge a ultrasonic cleaning machine general technical indicators as to stay ageing degree and resonant, impedance and impedance matching are already debugged before they go out, the key lies in you to do. Of course, the sound of ultrasonic cleaning machine and generator is now being silenced. The bonding mode of the oscillator is usually made of special cement, and the bolt fastening effect is good, but it is not suitable for maintenance. Frequency selection is cleaned according to the workpiece to decide, general material or on the surface is not very high, with 28 KHZ, more strict for cleaning, or had better choose high precision parts. This is because, the lower the frequency of the bubbles, the greater the when ultrasonic frequency is greater than 800 KHZ, there is no cavitation bubbles, this to be the effect of cleaning the surface of the cavitation corrosion is the lowest. In addition, the ultrasonic cleaning is the effect of the high pressure produced by an empty bubble in the instantaneous blast.
The main still should see you clean thing, clean the rough, no strict requirements to surface with low frequency is ok, but for some mesh class cleaning high frequency, it is best to this can reduce the workpiece of ultrasonic cavitation effect. Secondly depends on the choice of cleaning medium, weak alkaline medium SUS304 steel can, weak acid or not enough, easy to form in acoustic surface acidification, steel easy ageing.
The main cleaning parameters are: Material: the channel is made of stainless steel, acid and alkali resistant, and the appearance is beautiful and generous. Machine: can be customized according to customer's requirement. Power, frequency: adjustable, with unique ultrasonic generator, high energy conversion rate. 4, temperature control, temperature adjustable 0-110 ℃. Scaffolds can be customized according to requirements and actual needs.
