Home > categories > Consumer Electronics > Monitors > Computer boot, bit long sound, the monitor is not bright
Question:

Computer boot, bit long sound, the monitor is not bright

Computer boot, bit long sound, the monitor is not bright

Answer:

Make sure your monitor is not a problem, start a sound means you or your memory card loose or poor contact, dust if you are alone you pull out the memory card and clean up the dust and gold finger slot on the dirt, can use the rubber boot of course! There are other factors not shown by the above method. If you still have to show that you can put your memory to pull the replacement of another memory slot! Not detailed check your motherboard graphics interface, motherboard capacitors ` check your power = =! There is a special is your screen refresh the frequency is too high, can not enter the desktop cannot display method is in safe mode to remove the graphics driver into the system again! You try it if you leave a message to me
The memory is loose. No, it's too dusty. Pull it down and use the eraser. Just plug it in.
There is a problem with the memory bar. You pull it out, wipe it, and try again. If not yet. Pull out the graphics card and try again. If not. You change a memory bar. Generally long sound does not boot is a memory problem, did not plug, or bad.
Obviously, the memory is not plugged in.Tip: take down the memory bar, and then wipe your fingers and insert them back.
Memory is not plugged in,Pull it out and wipe your gold fingers,Then clean up the dust in the slot from the new clothes,As with graphics cards, unplug, clean, reinstall, go back.

Share to: