I opened the 1.5 cubic meters of horizontal biaxial mixer, stirring shaft machine barn is always with concrete, make people clear up a lot of trouble, a knowledgeable teacher to give a solution in indebted forever!
With no hoop what, this situation is usually appear after mixing unit to sink, because the mixer is no longer a level, and that a high axle always, you can try to adjust the feeding time, the time delay should be a good point to point axle is impossible.
Stop for a long time, do not hit the ash, then you can rinse, and it will stick, because you operate for 1, 5 square mixer, you can put 700 kilograms of 5~25mm stones, add 300 kg water, stirring 3~5 minutes, release... Do not put too much stones to prevent accidents such as stuffy machine...
Change the water inlet cover, and then add a high pressure water pump, the water inlet pipe should be adjusted.
In the concrete mixer cleaning, should pay attention to the following matters:First, regular maintenance procedures, the provisions of the project maintenance, maintenance operations, such as cleaning, lubrication, refueling, etc.Second, concrete mixer before starting, check the controller is good, after stopping, water and gravel into the mixing drum, 10~15 minutes for cleaning, and then water and Shi Ziqing out. If the operator should enter the mixing drum, the switch box shall be locked except for cutting off the power supply and removing the fuse.Third, clear the existence of concrete mixer tube concrete prohibition sledge, only clear with a chisel.Fourth, in the cold season, after the completion of the work, the use of water cleaning mixer drum, and the water pump, water tank, water pipe water net, so as to avoid water pump, water tank, pipe and other cold.
