Considerations for hand held aluminium foil sealing machine?
This machine is not suitable for metal container and metal cap and anodized aluminum paint cover on the metal surface, no heating press button, otherwise it will damage the machine, such as metal cap and anodized aluminum paint cover, aluminum foil can be screwed on the bottle cap.2, this machine is in use, the operator should always pay attention to the temperature sensing head, such as hot hot hand (about 80 DEG C) should stop working for natural cooling or use a fan induction head alignment sensor head forced rapid cooling, the temperature sensing head down to room temperature (25 degrees Celsius) again start to work, so the sensor head of high temperature damage.
6. This machine uses single phase three wire power line. In order to make the operator safe, make sure to use the single-phase three wire outlet. The ground must be dry in order to keep the insulation.7, the normal input voltage, such as the input power supply voltage is less than 160V, should stop working until the voltage is normal after work.8. The material of the induction aluminum foil must be consistent with the material of the sealed container.9, before the power supply, the induction head must be inserted into the induction air socket, and the nut is locked. Each machine is equipped with a random induction head, and the machine and induction head can not be changed freely.10 、 the machine is equipped with a safety tube of 5A, and no more than 5A safety pipes.11, the machine in use should maintain a good ventilation environment, can not block the ventilation of the chassis.
3, the machine is equipped with automatic overheat protection function, when the internal temperature of overheating, green "overheating" bright lights, you should immediately can continue to work out in the standby light or cooling.4, white glue boards often view the inductive head in front of the color, if there are serious undo charred discoloration, inductive head rib cover to check, whether the induction coil insulation paint carbonization or fall off, if this phenomenon should replace the coil head or the induction time, continue to use so as not to damage the host.5, when the induction foil area is too large, press the induction switch, time display immediately to zero without induction or red "overcurrent indicator" flashing with "drop" sound the alarm when the time should be increased by letter and the distance between the sensor head of the post, can work normally. Can use rubber boards and other things to do the stalls, do not use metal materials instead.
