I have this round dining table. Its iron base and wood top. The wood top is dented and the venner is damaged. I thought it would be cool to cover it with copper. The table is between 3 and 4 ft in diameter (can't recall exactly right now).What would be the best way to go about this? sheet vs. rolls. and any application advise would be helpfulthanks!
That sounds beautiful actually! I have done similar treatments to other objects for clients in my home remodel business. For an application like this, I recommend using a paint or a glaze. You can find all sorts of these at your local craft store. Read the instructions carefully to make sure you pick a product that will stick and that you use the proper type of seal so it doesn't start flaking off. Guilding powders and sheets are also great, but can be very expensive. Make sure you sand the top down so that the paint will adhere properly. Another idea if you want to get back to a truly smooth surface is to consider tiling the table top. You can find tile in every metallic color under the sun and the even have metallic grouts available now (I know the brand Laticrete has a great selection.even available in an epoxy which would be perfect for a durable, stain/mold/mildew proof finish). Yet another possibility, buy thin metallic tiles that are actually intended for use in ceilings and back splashes. They are easy to cut and install but they will probably not be durable enough to withstand heavy use. To solve this issue, have a piece of glass cut in the same size or slightly larger than your table top with smooth edges and place on top of your application. This will give you the look you are going for without worrying about wear and tear and ease of maintenance. Hope this helps! Scarlett
wow i have seen this done in an expensive resort it looked great, and i asked how it was done since i had to install the taps. this is what the cabinet maker did, purchased copper in 4 x 8 sheets. lit a huge bonfire, and threw them on. after a short time they discoloured into swirls, he pulled them off and cooled them down with water, when dry sprayed them with a sealer and lacquer to keep the colours. then used an epoxy glue( both the top and the copper waited until almost dry) and a lot of weight to stick them to the counter tops then trimmed them with a router sealed them once again and installed them. gold taps looked great with that. copper that's new and shiny worked the best. this resort he did it for caters to the rich an famous and only the best would do for this guy.
