Do you have any problems with laying artificial lawns?

Answer:

The green turf joints at each seam 2-3 cm, with a knife pushed from the middle of the joint cutting, so that the sides of the lawn as possible overlap, compact, and then cut with paper knife;

The white lawn section that will be otherwise woven must be hand cut into a white line of 120mm width and placed aside for use;

The turf moved down a side entrance direction spread, and to ensure that the A1 volume and the bottom line white fabric in the grass is consistent, then followed by the end of each volume turf line to the other end in advance, at the same time, to ensure that the line and line A14 or A15 volume in turf match, the white grass volume A28 in the skin and another line is consistent, in the grass spread process, reduce the wrinkle appears;

Put the line (measurement), find the center point of the site and the two semi circle, and according to the three point positioning ruler line, set the venue line and sideline intersection, and then set the exact position of field angle, point and line to the Pythagorean theorem, and then set the function point, line position and use the ink or paint line; pop.

In artificial grass products before entering the construction, first of all to the ground roughness, slope and surface appearance were detected, the error of flatness shall not exceed 3M ruler 3mm, according to the climate characteristics of Guangzhou more precipitation, drainage slope site shall not be less than 0.7%, such as roughness and slope is not up to the above indexes. You need to place the basis for rectification, in meet the above requirements, before entering the construction;