Does the ballast burn the led t8 lamp
So the starter for the LED tubes must be removed before and rectifier, directly connect the wire in the ends of the lamp holder is ok (note must end with only pick up a piece of the same line or zero line), if the installation errors appear before burning, LED lamp should not burn, can use normally after rewiring.
If leds installed directly in the original traditional bracket on the lamp holder with the starter and ballast, after electrify action will cause the starter due to short circuit burn out before the rectifier and the starter and there will be a short trip
Leds are powered by a built-in drive, and the ends of the tube are lit up by a single line at each end, and the voltage is 220V. Because the two pins on the same end of the LED tube are connected to one line
