Does the car tire come within or without?
Don't be too inflated. Because the inner soft and collapsible tube into the tyre after if suddenly a lot of inflatable tubes, may also fold before stretching is crushed, thereby causing damage to the tube. It is divided into two steps to install the inner inflatable, first filled in a small amount of gas, pause, then deflated, the folding part of tube flattening, pressure and then inflated to the provisions of the.
With tyre lever to pry into the tire, note the tyre lever cannot be inserted too deep, avoid punctured tube and pry off the bead bead.5. tire rim loading, should check and adjust the valve and align the wheel hub, inflated tire rotation, the valve position adjustment.6. tire rim and the rim wall should be uniform contact, should not be to one side, can be in the semi inflated tire will hit the ground or peripheral hammer blow to adjust.
When installed, the inner lining sleeve safely on the rim, the outer wall of the inner wall of the casing and inner tube are respectively coated with talcum powder, the tire side into the rim, the valve tube alignment hole rim, the inner tube from the gap into the rim and the rim, and the wheel rim of the hole from the outlet door mouth, with the valve cap, and then install the tire on the other side. Pry into the last tread, pry with a pry bar and remain stationary, and another pry the tire rod into the small part of the gap between the rim and the tire edge, pry the tire into the rim. If necessary, you can use foot or hammer to cooperate with you.
Some tire no balance marks, glue it with red, yellow, white, light blue color, mouth, and made a arrow shape, etc., in the side of the tire vulcanization, it says here is the lightest parts of tyre. When installing the inner tube, the valve face shall be directed against this mark to keep the balance of the tire running at high speed.
Tyre installation1. tire before installation, should carefully check the rim without distortion and deformation of tube leaks, there is no broken tyre bead, wall has no dirt and nail first, to prevent the installation after the fault in use.
