Hello, I am a just come in, so there are a lot of places do not understand, I see a programming problem in a book is to milling a slot but the problem that cutter knife so you don't always know about this knife is what this ah how to programming to write a program that ah have sent me a few typical examples come. Thank you for you
Keyway milling cutter can directly lower the knife, the end mill must be more than half of the blade in order to directly down the knife
The processing of AL, with a drill to drill under the knife hole, the bottom left margin of 0.3 to 0.4, when the diameter is larger than the cutter diameter. Machining with 2D shape processing, knife shaft, Z F-measure first, to give little bit sharp in about 300, manual postprocessing procedures do not directly add. Let lift knife, can save processing time.
The processing of AL, with a drill to drill under the knife hole, the bottom left margin of 0.3 to 0.4, when the diameter is larger than the cutter diameter. Machining with 2D shape processing, knife shaft, Z F-measure first, to give little bit sharp in about 300, manual postprocessing procedures do not directly add. Let lift knife, can save processing time.
Cross the edge of the milling cutter can directly down the knife, it is best to slash feed, and gradually deepen the milling groove
