Edge sealing machine can not boot, how to deal with?
Find an electrician, and then find drawings or manufacturers to make a phone call, in general, this failure is not a big problem, there may be a fault, it may be which protection switch started. Just check it out. What else is your machine?
Edge of the problem should be promptly contact with the manufacturers, this is to protect the sealing machine works, each manufacturer has its own settings, a sealing machine we used, Yuediao more problems, it did not take long to sell scrap. Now the 501-A Wanhui Albert edge machine, is not appropriate to call, immediately resolved, it is.
Is the start of a trip, you are using is not leakage protection switch ah, if it is possible is the problem of the leakage protection switch, and a sealing machine a boot when temperature did not reach any of the components, is not working, it can eliminate the motor fault, two. Edge machine boot is the first action of the pot heating elements, and some heating rod, and some heating plate, then you check whether there is a short-circuit or heating element of the power cord insulation is broken, leakage. If it is a heating element fault, this is to wait for a few seconds to turn on the machine, the thermostat's reaction time. Also, the simplest is to use the multimeter to open the machine, there is a large contactor for the power supply of the equipment, the back of the power line and ground wire are all connected, if it is through, that is, there is a place leakage. Don't put the power into the wire. If you don't know the electrician well, you'd better check it out.What woodworking machinery problem? Leave a message. I'm a carpenter's mechanic maintenance technician,
