Electric hot water bag how salt
The most likely reason for this is that the plug is not plugged in, and the plug must be pushed in until it is at the same level as the stopper. It may be hard to plug in winter, it is difficult to press down, before the plug can use hot water, soak the plug, so that the plug softened, and then forced into,Or plug up, no water leakage, the first plug in the power, heating, and a little bit hot, forced into.
If the heating time is short, there is boiling sound, solution, dilute the concentration of the liquid inside, refer to specific methods (two).Another reason is that internal air needs to be emptied. We use hot water is injected into tap water, tap water in a long time heating, will produce some gas. The plug is removed, the plug mouth filed, the air plug gathered in the mouth, with a water funnel top plate, gagged inside hold funnel, make the air slowly discharge, until the water outflow, the plug can be plugged, shaking, basically no water sound, you can.
Solution: remove the plug, water funnel top baffle gagged inside, the inside of the liquid poured out 1/3, and then use the water funnel into the water is 1/3, the inside of the liquid dilution, this will make the prolong of heating time, heating time is too short, easy to burn out the electric hot water bottle, shorten the hot water bag service life.
Hot water bag heating time is too slow (5~12 minutes is normal);Solution: remove the plug, water funnel top baffle gagged inside the hot water bag inside to add a little salt. Salt can be melted in the water, and then into the funnel, through the funnel, into the hot water bag, so that the hot water bag inside the salt concentration increased, will shorten the heating time.