EPSON stylus printer LQ-630K how to put the ribbon rail into the print head?

Answer:

It's not easy to imagine and understandYou put the box in the core with lewd printer driver frame the ribbon guide and ribbon set well is to slant along the print head on both sides of the groove insert more attention to it bulldozed to note that there is a middle small diamond plastic hook in the print ribbon guide frame that it can be installed guide to attention when the ribbon is not squeeze or print out is not blank word installed after the test print before you boot you try a little mobile print head see ribbon on the gear knob is rotated it

You try the following steps:1, it is critical: the paper thickness control rod hit the largest number of places (first recorded the previous figures)2. Move the print head to the appropriate position of the ribbon3, the ribbon cage core to relax a little bit, and then put the ribbon into the printer, the good position in place.4. Place the ribbon rail at the right angle and place it in the print head so that the ribbon is in a smooth state and placed below the print head.5, if you feel difficult to put in, you can use the other hand to rotate the ribbon knob at the same time, put into the movement will be easier.6, put in place and put it aside, move the whole print head and frame with your hand. If you move the ribbon evenly at this time, OK! Mission accomplished 90%7, finally, the paper thickness adjustment lever is restored to the original gear. Be accomplished！