FANUC System of machining center and XYZ ratio showed normal handwheel, rotate the handwheel XYZ week why not move ah
Confirm the following points,1, whether the mode switch hits the handwheel.2, the handwheel "select axis" knob, whether in the 0 gear, or B (fourth axis) gear.3, some hand wheel has a button on the side, you need to press the button to use the hand wheel.4, hand wheel whether there is a serious drop, may hand wheel inside contact bad, or broken line.
The mechanical locking button is pressed, the starting wheel is only in number and the axle is not moving
You'll still find FANUC maintenance engineer to check on me better.
