When the machining center uses a hand wheel, the handwheel moves one unit, and the corresponding shaft moves two or three units
The problem is not the handwheel between screw machine and limit switch with a problem can modify the parameters I can debug debugging but parameters to forget! But you can ask manufacturers and the parameters of each of the manufacturers are not the same can read the instructions
Hand wheel has been broken, it is recommended to change the hand wheel, hand wheel is very cheap, or ask manufacturers to repair...... There are too many lines in the hand wheel, so I don't know what parameters are available!
It should be a parameter setting problem.The handwheel moves one inch in English and 2.54 in metric millimetersThe number of machine tools moving is one metric millimeter
