Hot and cold faucet how to take water pipes
Requires a solid, because the kitchen faucet high frequency, coupled with being moved to move, easy to loose, so the lock nut must be tightened. At present, the market appeared some of the leading screw for the nut to increase the fixed, this solid effect is very good, if you can solve the problem of water to pull, the future will be a popular trend.
Install the thermostat before the first check the water pipe is not left hot right cold, remember not to hot and cold water pipe connected to the wrong, so that the leading can not work properly. Gas, solar water heaters can not use the thermostat, because the water pressure is too low. Do not forget to install hot and cold water filter.
Shower, bath faucet (wall) When you buy a shower, bathtub, wall faucet, you can choose the appropriate height to bury the water pipe. Hot and cold water pipe spacing must reach 15 cm. Before installation, do not forget to rinse the water pipe, so as not to water quality, concealed shower, bathtub faucet: the purchase of darkener faucet, the general spool of the faucet embedded in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be embedded. When the pre-embedded plastic cover of the spool should not be removed easily, so as not to damage the spool when cement and other chores are embedded. Also in the embedded spool should also pay attention to the upper and lower spool, left and right direction, so as to avoid spool error. Wall faucet embedded in the water pipe when the size of the deviation, can be used to adjust the kidnapping school.
Single handle basin faucet should pay attention to the diameter of the outlet, and now most of the market belongs to the hard tube water, so should pay attention to the height of the sink, from the basin down 35 points is the most appropriate. Installation, be sure to choose a special angle valve, and the angle valve and the wall must be hot and cold water pipe fixed. When it is found that there is a distance between the angle valve and the faucet on the faucet, it is necessary to purchase a dedicated extension tube to connect. Remember, do not use other water pipes to connect, because if the water pressure, it is easy to fall off, leaking, causing losses. If the inlet pipe is too long to exceed the outlet pipe, according to the need to cut off the part of the angle is not appropriate, then according to the need to moderate to the desired position. Remember: do not bend hard to 90 degrees or greater than 90 degrees. When installing the basin to the water, please do not forget to buy a small interface (leading short). Do not forget to rinse the pipes buried in the wall before installing.
