I want to produce date(palm fruit) paste industrially. The most important part in process is pitting. I want to know what procedures and machine being used to do this job.
Have you pressed the unlock button on the key fob? Have you turned the key in the driver's door lock, CCW, twice?
Is the leak under the tub, in the pipes or fittings between the pump and the pipes, requiring it to be drained and turned on it's side to fix? If so, the movements in doing that can certainly cause other fittings and seals to shift in position or be torqued to a condition that causes them to leak when its placed back down and refilled. If I were you, I would empty the tub and set it on end and go over every connection in the pipes carefully looking for evidence of cracking in the material in the joints, etc. You could try to test the pipes while the tub is on it's side, by using a plug on every output but one, and then a hose into one pipe, providing some water pressure in each segment of piping. If the leak is in the tub itself, and not the pipes or the pump under the tub, you can do the same effort, looking closely and carefully for leaks, patching the ones you see. then lift the tub up onto some concrete blocks that allow you to support it enough to fill it up, but still see underneath. then fill it and watch for leaks until you are confident they are all cured. Then drain, set back down in position off the blocks carefully, not twisting or banging it around, and refill again. Good luck!
Unplug u r oven from the wall that should disengage the door lock if not leave it unplugged and shake handle up and down and side to side!!It sounds like a faulty switch that lockes the door hope that's some help!
